Power Supply; To Load Batteries - Casio QV-30 Owner's Manual

Power Supply

The camera features a two-way power supply that lets you use either
batteries (AA-size Alkaline) or household AC current.

To load batteries

Be sure that camera power is turned off whenever loading or replac-
ing batteries.
1.
Slide the battery compartment lock on the bottom of the
camera in the direction indicated by arrow 1 1 1 1 1 , and swing
open the battery compartment cover as indicated by arrow
2 2 2 2 2 .
2.
Insert four batteries.
Be sure to use only AA-size Alkaline batteries. Never use
manganese batteries (see precautions on the next page).
Make sure that the positive + and negative - ends of the
•
batteries are facing correctly.
• Remove batteries from the camera if you do not plan to use it for
more than two weeks.
• Never recharge batteries, never allow direct connection between
two ends of a battery, and never try to take batteries apart.
• Do not expose batteries to direct heat or dispose of them by burn-
ing. Doing so can create the danger of explosion.
• Never mix batteries of different types.
• Dead batteries are susceptible to leakage, which can cause serious
damage to your camera. Remove batteries from the camera as
soon as you notice they are dead.
• The batteries that power this camera normally become warm when
they lose power. This does not indicate malfunction.
Standard Battery Life
The following shows standard battery life of batteries when the cam-
era is used without interruption under normal temperatures. Lower
temperatures can cause shortening of the standard battery life.
Battery type : LR6 (AM-3) alkaline dry cell
Battery Life : Approximately 2 hours
Approximately 96 images
(consecutive recording, one image per minute)
Getting Acquainted
Battery Handling Precautions
Incorrect use or handling of batteries can cause them to leak or burst
and seriously damage your camera. Be sure to note the following
important precautions to avoid problems with batteries.
13 14
Power Supply Getting Acquainted
Low Battery Indicator
A low battery indicator (
ing battery power drops below a certain level.
When this indicator appears, replace all four batteries with a fresh set
of new ones. Once the low battery indicator appears, you can expect
only about 10 more minutes of operation before total power failure.
Flash Memory
The camera features flash memory for storage of images. Flash
memory does not require electrical power to store data, so image
data is retained in memory even when you turn camera power off. If
batteries go dead, simply load a set of new batteries or connect the
AC adaptor and you will be able to view images in camera memory.
15 16
3.
Close the battery compartment cover.
• Press down on the battery compartment cover at the point
marked A in the above illustration until the cover locks into
place with a click.
• Use only LR6 (AM-3) type alkaline
dry cell batteries with this camera.
Never mix old batteries with new
ones. Failure to do so can result in
bursting or leaking of batteries, creat-
ing the danger of fire or personal in-
jury.
Caution
• Always make sure that the positive +
and negative - ends of the batteries
are facing correctly, as noted by the
markings on the camera itself. Im-
proper loading of batteries can result
in bursting or leaking of batteries, cre-
ating the danger of personal injury or
soiling of objects nearby.
) appears on the LCD whenever remain-
A