Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Winbest Pro-200
Summary of Contents for Winbest Pro-200
- Page 1 Pro-200 Edition Metal Detector...
-
Page 2: Table Of Contents
Notes Before Use - If you are new to use metal detectors, it is recommended to set the sensitivity to a median level. Lower the sensitivity slightly in the event of false signals. - If the sensitivity is set too low, it may miss some valuable target. After you have CONTENTS become familiar with the detector, you may try it at full sensitivity. -
Page 3: Preparation
Preparation Parts of the Metal Detector Search Coil Battery Compartment Control Box Headphone Jack Arm Support Top Stem Lower Connector and Knob Stem Locknut 3. Wind the cable around the stem. Insert the search coil cable plug into the five pin jack at the bottom of control box’s housing (5). -
Page 4: Batteries
Cautions: • Use only fresh batteries of the required size and recommended type. Control Panel • Always remove old or weak batteries; batteries can leak chemicals that can destroy electronic parts. • If you do not plan to use the detector for a long time, remove the batteries. HEADPHONES •... -
Page 5: Operation
Operation A reference for you to know what kind of metal is rejected depending on the DISC setting. Testing and Using the Detector Setting of DISC Metal Rejected The metal detector has two operation modes: ALL METAL & DISC. All metal is used Near 11:00 Iron to find all kinds of metal targets. -
Page 6: Care And Maintenance
Factors That Affect The Detecting Troubleshooting It’s difficult to have an accurate detecting result. It takes practice to get better Problem Reason Suggestion detection results. Sometimes the detecting may be restricted by some factors. Sensitivity set too high/ environmental electromagnetic Reduce SENSITIVITY •...
Need help?
Do you have a question about the Pro-200 and is the answer not in the manual?
Questions and answers