Healthrider HRTL20002 User Manual page 13

3. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a. Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.
b. If the walking belt still slows when walked on, please call our Customer Service Department, toll-free.
4. SYMPTOM: THE DISPLAYS OF THE CONSOLE DO NOT FUNCTION PROPERLY
a. If the speed display does not show a correct reading, remove the
key and UNPLUG THE POWER CORD. Remove the screws
from the sides and front of the hood. Carefully remove the hood.
Locate the Reed Switch (15) and the Magnet (43) on the left side
of the Pulley (90). Turn the Pulley until the Magnet is aligned with
the Reed Switch. Make sure that the gap between the Magnet
and the Reed Switch is about 1/8". If necessary, loosen the
Screw (45) and move the Reed Switch slightly. Retighten the
Screw. Re-attach the hood and run the treadmill for a few min-
utes to check for a correct speed reading.
5. SYMPTOM: THE WALKING BELT IS OFF-CENTER WHEN WALKED ON
a. If the walking belt has shifted to the left, first remove the key and
UNPLUG THE POWER CORD. Using the 3/16" end of the allen
wrench, turn the left rear roller adjustment bolt clockwise 1/4 of a
turn. Plug in the power cord, insert the key and run the treadmill
for a few minutes. Repeat until the walking belt is centered.
b. If the walking belt has shifted to the right, first remove the key
and UNPLUG THE POWER CORD. Using the 3/16" end of the
allen wrench, turn the left rear roller adjustment bolt counter-
clockwise 1/4 of a turn. Plug in the power cord, insert the key
and run the treadmill for a few minutes. Repeat until the walking
belt is centered.
6. SYMPTOM: THE TREADMILL SITS UNEVENLY ON THE FLOOR
a. Make sure that the two base pads and the stabilizer pad are attached to the treadmill. (See assembly steps
1 and 6 on pages 5 and 6.)
a
1/8"
15
43
45
Top
View
a
b
90
13