JRC JRL-2000F Manual page 30

6
BASIC OPERATION
After performing the SET operation, the central display will indicate the frequency band
that corresponds to the new settings. Always verify that the the exciter frequency matches
the indicated band setting of the JRL-2000F, and that the proper antenna is selected.
Also verify that the antenna VSWR matches the exciter's transmit frequency by turning
the PA switch OFF and keying the exciter. The MATCH LED should light green, indicating
a VSWR of 1.5:1 or lower. lf the MATCH LED is orange or red, see the "Supplements"
section below.
Supplements
• When the forced transmission signal line is not connected:
Because the exciter will not automatically enter transmission mode, manually key the exciter
to begin transmission. lf the SSB mode is selected, speak a few words into the microphone.
The JRL-2000F measures the operating frequency.
• When [fQ] is indicated in the central display:
This indicates that there is not sufficient input power to perform the automatic tuning operation.
Adust the power output control of the exciter to increase the drive Ievei. The JRL-2000F
can not perform the SET operation unless there is more than approximately 30 W input.
• When the color of the MATCH LED is orange or red:
This indicates an error in the stored preset data and proper antenna matehing has not
been achieved. Piease refer to section 6.3 and implement the automatic tuning operation.
Downloaded by
RadioManuai.EU