Rear Panel Controls - JRC JRL-2000F Manual

OPERATING CONTROLS AND FUNCTIONS
5
5.2 Rear Panel Controls
INPUT connector: PL-259
type connector for input
signal from exciter.
ANT1-ANT4 connectors:
PL-259 connectors for
outpul signal from JRL-
2000F to antenna(s).
CONTROL connector: The
interface control cable is
connected between this
connector and exciter.
ALCIADJ
ALC ADJ control: Used to
adjust the ALC Ievei. (See
section 6.6)
INPUT ANTI ANT2 ANT3 ANH
*
EXHAUST FANS: For the
PA unit and power supply
unit.
®
0
*
®
®
®
POWER SUPPL Y CONT
switch: When set to ON
position, the JRL-2000F's
power supply is controlled
by the front panel POWER
switch (and NCH-365
Renote Control Unit).
When set to EXTERNAL
position, the exciter can
be used to control the
power supply. (See
section 4.2.2)
I&A
GND terminal: For
connection to ground
system
FUSE: 15A fuse for AC
power line
115-
Downloaded by
RadioManuai.EU