ThermoPro TP-10 Manual

Digital food thermometer

Hide thumbs Also See for TP-10:

Table of Contents

Download this manual

Enlarged version

Digital Food Thermometer

Model No. TP-10

Key Definition

LCD

LCD (Liquid Crystal Display) – Displays all icons, temperature

and timer. The back light will flash Blue once the temperature

increases 10ºF, will change to Green when the temperature is

within 15ºF of the set temperature and will turn Red when it

reaches the set temperature. See LCD diagram for detailed

information.

Stand – Swings out and allow you to stand the receiver on

tabletop.

Sensor socket - Probe cable outlet hole.

BATTERY COMPARTMENT – Holds 2 AAA batteries.

1. MODE – Press to select thermometer or timer mode.

2. HR – In timer mode, press to set hour. Press & hold for 2 seconds,

SIDE

Sensor socket hole

STAND

-1-

Table of Contents

Do you have a question about the TP-10 and is the answer not in the manual?

Page 1 Digital Food Thermometer Model No. TP-10 Key Definition SIDE Sensor socket hole STAND LCD (Liquid Crystal Display) – Displays all icons, temperature and timer. The back light will flash Blue once the temperature increases 10ºF, will change to Green when the temperature is within 15ºF of the set temperature and will turn Red when it...
Page 2 the hours will increase 10 hours per second. In thermometer will show a small MEAT and a meat type such as BEEF. mode, press to increase the temperature value. Press & 2. Press MEAT to select meat type. PROG (program), GBEEF hold for 2 seconds, the temperature value will increase 10...
Page 3 2. Press HR and MIN button to set the timer. Press START/ 1. Please correct load 2*AAA batteries. STOP button to start countdown. “ ” will blink for every 2. Place steak and hot dogs on grill rack. second. 3. Insert probe sensor into the center of thickest portion of the 3.
Page 4 LIMITED 90 DAYS WARRANTY Cautions: ThermoPro warrants this product to be free of defects in parts, Always wear a heat resistant glove to touch the stainless steel materials and workmanship for a period of 90 days, from date probe sensor or wire during or just after cooking.