Can0/Can1 - ADF Wed HD67401-E4V User Manual

Industrial Electronic Devices

CAN0/CAN1:

The connection of both CAN (CAN0 and CAN1) in the HD6740x-E4x-xxx
device must be made with a 3way MiniFit Female connector. The pinout of
Male Mini-Fit connector of the board is at right side of the page.
The connection of both CAN (CAN0 and CAN1) in the HD6740x-E7x-xxx
device must be made with a AMP SuperSeal 1.5 Male connector. The pinout
of Female connector of the board is at right side of the page.
The termination of both CAN (CAN0 and CAN1) line, with a 120Ω resistor, in
the HD67411-Exx-xxx is made internally of the device; when the order is
performed. If the device have the CAN0 terminated the code is the follow:
HD6740x-Exx-Yxx; otherwise is this other: HD6740x-Exx-Nxx. If the device
have the CAN1 terminated the code is the follow: HD6740x-Exx-xYx;
otherwise is this other: HD6740x-Exx-xNx.
Cable characteristics:
DC parameter:
AC parameters:
Length
ADFweb.com Srl – IT31010 – Mareno – Treviso
Impedance 70 Ohm/m
Impedance 120 Ohm/m
Delay 5 ns/m
Baud Rate [bps] Length MAX [m]
10 k 5000
20 k 2500
50 k 1000
100 k 650
125 k 500
250 k 250
500 k 100
800 k 50
1000 k 25
User Manual CAN Repeater
Document code: MN67401_ENG Revision 1.002
INFO: www.adfweb.com Phone +39.0438.30.91.31
Page 8 of 16