Philips SNA6500 User Manual page 39

Philips wireless router user manual
Hide thumbs Also See for SNA6500:
Table of Contents

Advertisement

Flags
Flooding cracker block time.
Fragmentation half-open wait
Gateway
Gateway
Gateway
Group Key Re-Keying
Half-open fragmentation detect
sensitive time period.
Home networking
Incomplete TCP/UDP sessions
(per min) HIGH
Incomplete TCP/UDP sessions
(per min) LOW
Information
Interface
Incomplete TCP/UDP sessions detect
as incomplete.
Interleaved Path CRC Error
Interleaved Path HEC Error
IP Address
IP Subnet Mask
IP Address
Internet
Interface
Key Entry Method
Key Provisioning
Lease Time
Loss of Signal Defect
Maintenance
Maximum half-open fragmentation
packet number from same host
Indicates the route status:
C = Direct connection on the same subnet.
S = Static route.
R = RIP (Routing Information Protocol) assigned route.
I = ICMP (Internet Control Message Protocol) Redirect route.
Default 300 sec: Length of time from detecting a flood attack to blocking the attack.
Default 10 sec: Configures the number of seconds that a packet state structure
remains active. When timeout value expires, the router drops the
unassembled packet, freeing that structure for use by another packet.
Displays system IP settings, as well as DHCP Server and Firewall status.
The IP address of the router at the next hop to which frames are forwarded.
Enter the WAN IP address of the gateway to the remote network.
The period of renewing broadcast/multicast key.
Default 10000 msec: Length of time before a half-open fragmentation session is
is detected as half-open.
Sets the TCP/IP configuration for the ADSL Wireless Base Station LAN interface and
DHCP clients.
Default 250 sessions: Maximum number of allowed incomplete TCP/UDP sessions
per minute.
Default 200 session: Minimum number of allowed incomplete TCP/UDP sessions
per minute.
Displays the number of attached clients, the firmware versions, the physical MAC
address for each media interface, and for the ADSL Wireless Base Station, as well as
the hardware version and serial number.
The WAN interface to be configured.
Default 300 msec: Length of time before an incomplete TCP/UDP session is detected
sensitive time period.
The number of Interleaved Path Cyclic Redundancy Check errors.
Interleaved Path Header Error Concealment errors.
The IP address of the ADSL Wireless Base Station.
The subnet mask of the network.
Traps are sent to this address when errors or specific events occur on the network.
Displays WAN connection type and status. Click the Connect button to connect to
your ISP.
The local interface through which the next hop of this route is reached.
Select Hex or ASCII code for encryption
Select Static if there is only one fixed key for encryption.
If you want to select Dynamic, you would need to enable 802.1x function first.
Set the IP lease time. For home networks this may be set to Forever, which means
there is no time limit on the IP address lease.
Momentary signal discontinuities.
Contains options to backup & restore the current configuration, restore all
configuration settings to the factory defaults, update system firmware, or reset the
systems.
Default 30: Maximum number of half-open fragmentation packets from the same
host.
key generation.
EN
39

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Snk5620/05Sna6500/05Sna6500/00Snk5620/00

Table of Contents