Table of Contents
Advertisement
WARNING AND ERROR MESSAGE
It incorporates a variety of functions for the systems to verify processes
and the state of the electronics. In case of an error the screen will
display the cause of error and emit an audible sound.
Incorrect polarity connected.
The battery is interrupted.
CONNECT ERROR
The Battery connection is wrong.
CHECK
MAIN
PORT
BALANCE CONNECT
The balance connect is wrong.
ERROR
Input voltage less than 11V.
DC IN TOO LOW
Input voltage higher than 18V.
DC IN TOO HIGH
CELL ERROR
Voltage of one cell in the battery pack is too low.
LOW VOLTAGE
CELL ERROR
Voltage of one cell in the battery pack is too high.
HIGH VOLTAGE
CELL ERROR
Voltage of one cell in the battery pack is invalid.
VOLTAGE-INVALID
CELL NUMBER
The cell number is wrong.
INCORRECT
The internal temperature of the unit goes too high.
INT.TEMP.TOO HI
The external temperature of the unit goes too high.
EXT.TEMP.TOO HI
The battery capacity is more than the maximum
OVER CHARGE
CAPACITY LIMIT
capacity which the user sets.
The charging time is longer than the maximum
OVER TIME LIMIT
charging time which the user sets.
The battery voltage is higher than the maximum
voltage which the user sets when charging in
BATTERY WAS FULL
balance mode.
30
SPECIFICATION
DC Input
Charge circuit power
Charge current range
Discharge current power
Discharge current range
Current drain for balancing port
NiCd/NiMH battery cell count
LiPo/LiFe/Lilon cell count
Pb battery voltage
Net weight
Dimension
(stated values refer to one charger except built-in power supply, dimension & weight)
THE SET CONTAINS
1. G-force G6 Charger
2. Plug-in battery clamps
3. XT60 DC Cable
4. Dean connector with
banana plug cable
5. Tamiya charging cable
6. Futaba RX charging cable
7. 3pin XH-TP/FP adaptor cable
SPECIFICATION
11-18Volt
DC
Input
80W
0.1-10.0A
10W
0.1-2.0A
200mA/cell
1-15Cells
1-6Cells
2-20V
300g
138.5x80.5x28.5mm
1
2
6
4
3
5
7
31
Advertisement
Table of Contents
