Compressor Kit; Jump Starting; Jump Starting - North; America - Cadillac ATS 2018 Owner's Manual

The tire sealant and compressor kit
has an accessory adapter located in a
compartment on the bottom of its
housing that may be used to inflate
air mattresses, balls, etc.
Removal and Installation of the
Sealant Canister
To remove the sealant canister:
1. Unwrap the sealant hose.
2. Press the canister release
button (9).
3. Pull up and remove the canister.
4. Replace with a new canister
which is available from your
dealer.
5. Push the new canister into place.
Storing the Tire Sealant
and Compressor Kit
To access the tire sealant and

compressor kit:

1. Open the trunk. See Trunk 0 43.
2. Lift the cover.
3. Remove the strap.
4. Remove the tire sealant and
compressor kit.
To store the tire sealant and
compressor kit, reverse the steps.
VEHICLE CARE

Jump Starting

Jump Starting - North

America

For more information about the
vehicle battery, see Battery - North
America 0 272.
For the 3.6L V6 twin turbo engine
(LF4) only, there is an optional low
power battery that can be used for
track events. If the vehicle has the low
power battery installed and the
battery has a low State of Charge
(SOC), the vehicle can be jump started
the same way as if the regular battery
was in the vehicle using the following
procedure. For more information on
the low power battery, see Battery -
North America 0 272 and Track Events
and Competitive Driving 0 177.
If the battery has run down, try to use
another vehicle and some jumper
cables to start your vehicle. Be sure to
use the following steps to do it safely.
317