GE IC754VSB06MTD Hardware User's Manual page 52

3
The QuickPanel View provides two methods for setting an IP address:
DHCP (Dynamic Host Configuration Protocol). This is the default
method that is carried out automatically.
Note:
Manual method. You uniquely specify the numeric addresses for the
QuickPanel View, the Subnet Mask, and the Default Gateway (if
applicable).
Note:
To set an IP address
1. From the Control Panel, tap
The Connection window appears.
3-24 6" QuickPanel* ViewBasic, Monochrome, Round Bezel – September 2010
There must be a DHCP server on the connected network for a
valid IP address to be assigned. Contact your network
administrator to ensure correct DHCP server configuration.
Use a crossover cable to connect the QuickPanel View directly
to a PC. When connecting to a LAN HUB, use a
straight-through cable. Contact your network administrator for
further information.
Network and Dial-up Connections.
GFK-2327B