EarthWise CVPS41008 Operator's Manual

EarthWise CVPS41008 Operator's Manual

Electric convertable 2 in 1 pole saw / chain saw

Advertisement

/ CHAIN SAW
CONVERTIBLE 2 IN 1
CVPS41008
CVPS41010
This product

Advertisement

Table of Contents
loading

Summary of Contents for EarthWise CVPS41008

  • Page 1 / CHAIN SAW CONVERTIBLE 2 IN 1 CVPS41008 CVPS41010 This product...
  • Page 2 the saw and/or handles CAUTION: Never use guard as a handle. Never grasp the unit by the guard. Failure to heed this warning can result in serious personal injury. chain saws.
  • Page 3 distance WARNING: California Proposition 65: This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Fig. 1 Chain saw w/chain and bar Telescoping pole Fig. 2 CONVERTING FROM POLE SAW TO CHAIN SAW. The electric chainsaw is a separate operating unit when not assembled to the telescopic pole.
  • Page 4 INSTALLING/REPLACING THE GUIDE BAR AND CHAIN...
  • Page 5 INSTALLING/REPLACING THE GUIDE BAR AND CHAIN...
  • Page 6 LEFT HAND CUTTERS RIGHT HAND CUTTERS CORRECT TOP PLATE INCORRECT TOP PLATE FILING ANGLE FILING ANGLE LESS MORE THAN 30 THAN 30 CORRECT SIDE INCORRECT SIDE PLATE PLATE FILING FILING ANGLE ANGLE HOOK BACKWARD SLOPE CUTTING CORNER SIDE TOP PLATE RAKER CLEARANCE PLATE .025 in.
  • Page 7 DO NOT PULL the trigger until you are ready to make a cut. When using the chain saw place your right hand on the rear handle and your left hand on the front handle with your WARNING: Be aware of the cord while operating the saw. Keep thumbs and fingers encircling the chain saw handles.
  • Page 8 and/or handles When using the chain saw place your right hand on the rear handle and your left hand on the front handle with your thumbs and fingers encircling the chain saw handles. When using as a pole saw place PLANNED LINE OF FALL SAFE RETREAT...
  • Page 9 PRUNING LIMBING 2nd Cut-Pruning Cut(to avoid pinching) 4th Cut- Final Stub Cut 1st Cut-Pruning Undercut(to avoid splintering) 3rd Cut-Stub Undercut (to avoid splintering) Make first cut six inches from tree trunk on underside of limb. Use top of guide bar to make this cut. (Cut 1/3 through diameter of limb.) Move two to four inches farther out on limb.
  • Page 10 and chain oil, Reverse chain so that cutters face the right direction...
  • Page 11 CVPS41008 CVPS41010 2.75m (9 ft) 2.8m (9 ft 2 in) LOCK OFF BUTTON TRIGGER SWITCH...

This manual is also suitable for:

Cvps41010

Table of Contents