Notes; Installation; How To Adjusting The Evr; What Is "Initial Data - JVC TK-C1310E Service Manual

2.4 NOTES

2.4.1 Installation

To install the adjustment program, perform the following proce-
dure.
1) If you have any programs currently installed in the serial I/O
port, remove them.
2) Insert the adjustment program diskette into a floppy diskette
drive.
3) From Windows 95, select "Run" from the "Start" button
and type "a:\setup (or b:\setup)" depending on which drive
contains the diskette.
4) Follow the instructions on the screen.

2.4.2 How to adjusting the EVR

Click the " " or " " button to the right of the adjustment
items displayed on the screen to adjust EVR to the required
value.
These buttons

2.4.3 What is "Initial Data"

The initial data loaded at "2.5 INITIALIZE" consists of preset
adjustment values. Therefore, once the adjustment procedure
is started, all adjustment should be done from beginning to the
end. Otherwise, the preset adjustment values would be written
as the adjustment data.

2.4.4 How to write adjusted data to EEPROM in camera

The adjustment values are written in the EEPROM of the cam-
era when you click "YES" from the "Are you sure to write
EEPROM?" message box which is displayed at the end of the
adjustment.
If you abort the adjustment in the middle, the adjustment
values in the camera are not changed (the adjustment val-
ues which have been set before the start of the adjustment
remain unchanged).
2-4