ALIGNMENT INSTRUCTIONS
WHITE BALANCE
1. RGB Reference R
2. Beam Reference LOW ( 288, 301 : 10Cd/ )
HIGH ( 288, 301 : 100Cd/
3. Adjust G, B Gain with select Menu G,B of BIAS, DRIVE of select Menu so that R, G, B Bars
are on the center position of the analog meter. If R Analog meter is not on center, control
the Brightness +/- of user Remocon so as R Analog meter to be on the center position.
SUB BRIGHT
1. Pattern : Retma
2. Adjust the SUB BRIGHT with the select Sub Bri by volume UP/DOWN keys.
so that only H-Center parts of picture can be seen.
DOUBLE TEXT CENTER
1. Pattern : Pattern RED
2. Select Menu
3. Select DT in SVC menu time to see the Double Text Picture.
( Left : RF Picture, Right : Text Picture )
4. Change the Double Text control keys volume UP/DOWN keys so that the left edge of text
picture concur with the right edge of RF picture.
WIDE MODE
1. Locate the cursor on 'Wide' in SVC Menu.
2. 'Yes' changes the display to 16:9 mode.
3. 'No' change the display to 4:3 mode.
TUNER SELECTION
1. DWE : Partsnic Tuner S/S Tuner
2. PHI : Philips Tuner
3. SIE : Siel Tuner
FLAT MODE
1. Locate the cursor on 'FLAT' in SVC Menu.
2. 'Yes' changes the display to FLAT CRT mode.
3. 'No' change the display to Normal CRT mode.
2
m
2
m
)
10