Breath Test At Vehicle Start - Dräger Interlock 7000 Instructions For Use Manual

5

Breath Test at Vehicle Start

5.1 Preparation
Do not use or consume any product other than water within 15
minutes of using the device.
5.2 Turning on the System
To turn the system on:
1. Insert a clean, dry mouthpiece into the Interlock device.
2. Insert the key into the ignition switch.
3. Turn key to the on position (usually two clicks).
4. The Interlock will show "Warming Up" on the display screen
and there will be a steady blue light on the device.
5. When the Interlock is ready for the breath sample it will dis-
play "Ready for Test - Please Blow" on the screen and the
blue light will flash repeatedly.
6. Take a few normal, even breaths.
7. Take a deep breath and put your lips around the mouth-
piece.
8. Provide a steady blow into the mouthpiece by exhaling nor-
mally. As you blow into the Interlock a tone will sound and
the light will turn off. This means you are blowing correctly.
Do not stop.
9. When the tone stops and the blue light turns back on imme-
diately give a sharp suck back until you hear a beep.
5.3 Test Results
The Interlock will display "Test Passed" or "Test Failed" if the
breath sample was given correctly.
Test Passed: If the breath sample is below the set-point the
message "Test Passed" will appear and a green light will come
on. A countdown will start on the interlock showing how much
time you have to start the vehicle. Turn the key to start your ve-
hicle.
Test Failed: If the breath sample is above the set-point the
message "Test Failed" will appear and a red light will come on.
The vehicle will not start.
NOTICE
i i
Note that when you turn off your vehicle the Interlock
will begin a countdown. Within that time period you can
restart the vehicle without needing to give another
breath test.
Dräger Interlock 7000 User Manual V1.1 2014
5.4 Failing the Breath Test
If you fail the breath test:
 The vehicle will not start.
 The device may go into temporary lockout.
 If the alcohol content of your breath is very high the tempo-
rary lockout may be longer.
 The display will show you how much time remains in the
"Temporary Lockout" period.
5.5 Breath Test Messages
If you hear beeping or see a red light flash during a test, stop
and look at the display. The displayed message will tell you
what went wrong and you can retake the test.
Blow Longer! Repeat Test:
 Means you did not blow long enough.
Press the OK button and the Interlock will prepare to test

again.
Take the test again and blow until the tone stops.

Blow Stronger! Repeat Test:
 Means you did not blow hard enough.
Press the OK button and the Interlock will prepare to test

again.
Take the test again and blow a little harder.

Suck after Blow:
 Means that you did not do the suck back correctly.
Press the OK button and the Interlock will prepare to test

again.
Take the test again and perform a sharp suck-back when

the tone stops. Suck until a beep sounds.
Interferent Detected:
Press the OK button and a countdown will begin.

 Once the countdown is complete take the test again.
Breath Test at Vehicle Start
5