Table of Contents
Advertisement
Dial Pointer Brightness, con't
UP: DIAL BRIGHTNESS". Refer to figure 4.
SETUP: DIAL
BRIGHTNESS:
Figure 4
2. Rotate the TUNE/ADJUST Control to select the
desired brightness. The range of adjustment is
from 0 to 20.
3. Proceed to the next Setup Menu Item or press the
MONO/SETUP Push-button to exit the Setup
Mode. "How to operate the Tuner" starts on page
20.
Information Display Brightness
The brightness level of the Front Panel Information
Display may be changed from the default setting. To
change the brightness perform the following steps:
1. Press the MONO/SETUP Push-button until the
Setup Mode is active. Then rotate the PRESET/
MENU Control to select Setup Menu item "SET-
UP: DISPLAY BRIGHTNESS". Refer to figure 5.
SETUP: DISPLAY
BRIGHTNESS:
Figure 5
2. Rotate the TUNE/ADJUST Control to select the
desired brightness. The range of adjustment is
from 1 to 4.
3. Proceed to the next Setup Menu Item or press the
MONO/SETUP Push-button to exit the Setup
Mode. "How to operate the Tuner" starts on page
20.
16
Information Display Auto Fade
The Front Panel Information Display Auto Fade
Feature may be activated by performing the following
steps:
15
1. Press the MONO/SETUP Push-button until the
Setup Mode is active. Then rotate the PRESET/
MENU Control to select Setup Menu item "SET-
UP: DISPLAY AUTO FADE". Refer to figure 6.
2. Rotate the TUNE/ADJUST Control to select ON.
Approximately 17 seconds after there is no change to
the operating function (Front Panel or Remote Con-
trol), the Front Panel Infomation Display will blank
out until an operating function is accessed.
3. Proceed to the next Setup Menu Item or press the
MONO/SETUP Push-button to exit the Setup
Mode. "How to operate the Tuner" starts on page
20.
Remote IR Sensor
When an external IR Sensor is connected to the MR88
3
and located in the same room as the tuner, it is advis-
able to disable the built-in IR Sensor located on the
Front Panel. Disable the sensor by performing the
following steps:
1. Press the MONO/SETUP Push-button until the
Setup Mode is active. Then rotate the PRESET/
MENU Control to select Setup Menu item "SET-
UP: REMOTE IR SENSOR". Refer to figure 7.
2. Rotate the TUNE/ADJUST Control to select OFF.
SETUP: DISPLAY
AUTO FADE: OFF
Figure 6
SETUP: REMOTE
IR SENSOR: ON
Figure 7
3. Proceed to the next Setup Menu Item or press the
MONO/SETUP Push-button to exit the Setup
Mode. "How to operate the Tuner" starts on page
20.
Remote Control Power Command
In a typical audio system, the MR88 switches On and
Off with the McIntosh Preamplifier or A/V Control
Center when a Power Control Connection is made
between the units. When the MR88 is used alone, it
can be switched On or Off using the Push-button on
the MR88 Remote Control. To activate the Remote
Control On/Off feature perform the following steps:
1. Press the MONO/SETUP Push-button until the
Setup Mode is active. Then rotate the PRESET/
MENU Control to select Setup Menu item "SET-
UP: REMOTE POWER IR". Refer to figure 8.
SETUP: REMOTE
POWER IR: DISABLE
Figure 8
2. Rotate the TUNE/ADJUST Control to select EN-
ABLE.
3. Proceed to the next Setup Menu Item or press the
MONO/SETUP Push-button to exit the Setup
Mode. "How to operate the Tuner" starts on page
20.
Advertisement
Table of Contents
