Page 1
MA200 Series 3 Features of the MA200 • 120 Watts RMS output per channel • MOSFET output stage for greater clarity • Over temperature monitoring • Open & Short Circuit Protected • Loudspeaker DC protection • Peak and Normal indicators for each channel •...
MA200 if connected to an input. A signal of 775mV RMS (0dBm) is required to achieve full power output with the volume controls set on maximum.
Page 3
User Guide MA200 Inputs Connect the input signal to the ¼” mono jack socket on the rear panel. Use a screened cable for the input signal to avoid interference. If connecting from a stereo output, use a ¼” stereo jack plug to two ¼” mono jack plugs splitter lead. The input for the left channel is located towards the right of the amplifier when viewed from the back.
User Guide MA200 For speakers connected in PARALLEL on each channel: The following combinations MAY be connected Speakers Combined impedance 1 × 16 W 16 W 2 × 16 W 3 × 16 W 5.3 W 4 × 16 W 1 ×...
Page 5
NEVER install the amplifier in a sealed cabinet. Short circuit protection. The MA200 is protected against short-circuits on the outputs. If this happens, it will limit its output current to a safe level until the short circuit is removed. A short circuit should be removed as soon as it is discovered, as the amplifier is not intended to be run indefinitely into a short circuit.
Page 8
User Guide MA200 Guarantee This product is guaranteed for a period of 12 months against faulty components or manufacture from the date of purchase. Upon proof of purchase, NJD shall, at its own option, repair or replace the defective item at no cost to the purchaser.