Section 3 Operation Instructions - Peco Z-trimmer ZT-3000 Operator's Manual

Section 2 Mounting Instructions Cont.
NOTE: Route the power cable before connecting the
cable to the battery. After the Z-trimmer has been
secured to the mowing deck, connect the main power
cable to the mower battery (connect the
positive terminal and the white wire to the negative
terminal). Route the cable around the outside of the
operator seat so that the cable does not interfere with
the seat or the control arms. Keep cable away from all
heat sources. Use zip-ties to secure the power cable,
once the best routing has been determined.

Section 3 Operation Instructions

When not in use, the Z-Trimmer should be in the upright
position with the latch hook secured. See Figure 3a.
Figure 3a
Latch Hook
Secured
Trimming
1. Release the latch hook and lower the trimmer into the
down position. Refer to Figure 3b.
Figure 3b
Lower Trimmer
Into Position
red wire to the
Latch
Hook
Release
Latch Hook
5
Trimming
To activate trimmer head, lift the toggle switch cover and
flip the toggle switch forward. To de-activate the trimmer
head, push the toggle switch cover down. Refer to
Figure 3c.
Figure 3c
Toggle
Switch
NOTE: If the circuit breaker on the Z-Trimmer trips,
close the toggle switch cover, wait five seconds and
then push the reset button before turning on.
Edging
To position the trimmer head for edging, loosen the star
knob shown in Figure 3d, rotate the trimmer head into
the position desired for edging and re-tighten the star
knob.
Figure 3d
Toggle
Switch Cover
Star
Knob
Rotate Trimmer
Head