Charging The Battery; Battery Removal; Battery Installation - STACYC Stability Cycle Owner's Manual

Hardware/Loose Parts: Check all hardware, such as nuts, bolts, cables, fasteners, etc. to
ensure they are secure. There should not be any unusual rattles or sounds from loose parts or
broken components. If the unit is damaged, do not ride it. Reference "Warnings" listed in this
manual.
Safety Gear: Check that proper protective gear, such as an approved and properly fitted safety
helmet, eye-wear, athletic shoes (Closed toe shoes with rubber soles), elbow pads, kneepads,
etc., are in place prior to riding. Keep shoelaces tied and out of the way of the wheels, motor
and drive system. NEVER RIDE BAREFOOTED OR IN SANDALS.
Laws and Regulations: Check and obey any local laws or regulations prior to riding.
Insurance: Verify with your insurance company that your existing insurance policies provide
necessary coverage for stability cycle use.

CHARGING THE BATTERY:

Remove battery from stability cycle and place on charger. Refer to instructions pro-
vided by battery and charger manufacturer. The stability cycle should be turned OFF
and the battery removed when unit is not in use. If the power switch is left on, the
battery loses its charge.
BATTERY:
Note: The stability cycle should be turned OFF and the battery removed when unit is
not in use. If the power switch is left on, the battery loses its charge.
Battery Release
Battery Terminal
Button/Latch
Location

BATTERY INSTALLATION:

Note: The stability cycle should be turned OFF and the battery removed when unit is
not in use. If the power switch is left on, the battery loses its charge.
P a g e | P a g e | 10 10
Battery Information
Label
DOC 001 REV A
1. Locate battery and orient as shown,
it is easier if you turn the handlebars
left or right 45 degrees.
2. Slide battery into slot on the front of
the down tube of the STACYC.
3. There is a point where the battery release latch/button provides some
resistance. Push the battery past this point.
• You should hear a click, and this gap should be closed.

BATTERY REMOVAL:

1. Turn the handlebar 45 degrees from straight.
2. Depress the battery release latch/button and slide battery out of slot in the direc-
tion shown.
Battery Release
Button/Latch
DOC 001 REV A P a g e | 11