Fm Radio - SanDisk Sansa Clip v2 Manual

Chapter 5. The Main Menu

5.9. FM Radio

This menu option switches to the radio screen. The FM radio has the ability to remember
station frequency settings (presets). Since stations and their frequencies vary depending
on location, it is possible to load these settings from a file. Such files should have the
filename extension .fmr and reside in the directory /.rockbox/fmpresets (note that
this directory does not exist after the initial Rockbox installation; you should create it
manually). To load the settings, i.e. a set of FM stations, from a preset file, just "play"
it from the file browser. Rockbox will "remember" and use it in PRESET mode until
another file has been selected. Some preset files are available here:
It is also possible to record the FM radio while listening. To start recording, enter the
FM radio settings menu with Long Select and then select Recording. At this point,
you will be switched to the Recording Screen. Further information on Recording
can be found in section
Key
Left, Right
Long Left, Long
Right
Volume Up,
Volume Down
Home
Power
Play
Submenu
Select
Long Select
The Rockbox manual
Figure 5.4.: The FM radio screen
5.8 (page 41).
Action
Change frequency in SCAN mode or
jump to next/previous station in PRE-
SET mode.
Seek to next station in SCAN mode.
Change volume.
Leave the radio screen with the radio
playing.
Stop the radio and return to Main Menu.
Mute radio playback.
Switch between SCAN and PRESET
mode.
Open a list of radio presets. You can view
all the presets that you have, and switch
to the station.
Display the FM radio settings menu.
(version 3.14)
42
FmPresets.
Sansa Clip v2