Subscribe to Our Youtube Channel
Related Manuals for Multiform LEC430
Summary of Contents for Multiform LEC430
-
Page 1: Operating Instructions
LEC430 INSTRUCTION MANUAL Iss2 LIGHTMIX 430 LIGHTMIX 430 Model LEC430 Operating Instructions Contents Page No. 1. INTRODUCTION. 2. FRONT PANEL LAYOUT 2.1 Manual Controls. 2.2 Effects Selectors. 2.3 Chase Effects. 2.4 Effects Modifiers. 2.5 Sound to Light Effects. 2.6 Crossfade Effects. -
Page 2: Introduction
LEC430 IINSTRUCTION MANUAL Iss2 LIGHTMIX 430 1. INTRODUCTION The LIGHTMIX 430 is a fully dimmable 4 channel club controller with low voltage outputs to drive up to 4 slave dimmer packs. Eight switched outputs are provided, four of which may be used to enable the dimmer packs. -
Page 3: Lec430 Instruction Manual Iss2 Lightmix
LEC430 INSTRUCTION MANUAL Iss2 LIGHTMIX 430 SOUND SYNC: Each step of the pattern is synchronised to the beat of the music. When the music stops the pattern reverts to automatic operation after 5 seconds. AUTO REVERSE: The direction of the chase pattern is reversed by a single press of this button. If the button is latched the direction will reverse automatically every 16 steps. -
Page 4: Rear Panel Facilities
LEC430 IINSTRUCTION MANUAL Iss2 LIGHTMIX 430 ZONE/SWITCHED OUTPUTS (A-D): Each slave dimmer pack can be enabled or disabled using these switches. A yellow LED indicates that the pack is enabled. If the zone enable facility is not required, these buttons can be used to control four additional switched effects. -
Page 5: Installer Options
LEC430 INSTRUCTION MANUAL Iss2 LIGHTMIX 430 3.6 Installer Options There is a bank of 4 small DIL switches that cater for a number of set up options. 1. DISABLE AUTOSTART:- at switch-on the controller starts up with the chase pattern running. -
Page 6: Switched Enable Input/Outputs
LEC430 IINSTRUCTION MANUAL Iss2 LIGHTMIX 430 5.2 Switched Enable Input/Outputs If a remote switching panel such as the LIGHTMIX (TSB431) or REMOTE SWITCH PANEL (LSP430) is used to enable the MULTIPAC's it should be connected to this DIN socket. The power for the switch panel can be supplied from the LIGHTMIX via pin 6 of this cable. -
Page 7: Wiring Diagrams
LEC430 INSTRUCTION MANUAL Iss2 LIGHTMIX 430 7.WIRING DIAGRAM A typical Club installation using a LIGHTMIX 430 and a LIGHT FINGERS controlling 4 Zones of four channel lighting effects, plus 4 Motors and 8 Switched Effects. The Four Zones are enabled by 4 Channels of the LIGHT FINGERS which is also used to control the 8 Switched Effects. -
Page 8: Input And Output Connectors
LEC430 IINSTRUCTION MANUAL Iss2 LIGHTMIX 430 8. INPUT AND OUTPUT CONNECTORS 9. TECHNICAL SPECIFICATION Supply Voltage: 15-20V D.C. unregulated or 12V D.C. regulated. Supply Current: 300 m.A. + output loading. Supply Fuse (Internal): 20 x 5 m.m. - 500m.A. Q.B.
Need help?
Do you have a question about the LEC430 and is the answer not in the manual?
Questions and answers