Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for eurodib USF-33S
Summary of Contents for eurodib USF-33S
- Page 1 WINE COOLER INSTRUCTIONS MANUAL...
- Page 2 Dear Users： Thanks for choosing our wine coolers. You will enjoy our kind, prompt and considerate service after you buy our products. This manual would apply to various models of our wine coolers. The model you choose may have a little difference from the description in this manual, but please don’t worry about，...
- Page 3 7. Data Parameters Catalogue USF-3 USF-54 USF-72 USF-128 USF-168 Notes ------------------------------------------------------------------------- 4 Structure of Wine Coolers----------------------------------------------- 6 USZ-16 USF- USF-5 USF-72 USF-128 USF-168 Model USZ-54 USZ-72 USZ-128 Installation ----------------------------------------------------------------- 12 USF-168 Operation Instruction --------------------------------------------------- 13 Climate Type Care and Maintenance ------------------------------------------------- 22 Volume (L) Troubleshooting -----------------------------------------------------------24 Bottles...
- Page 4 The light does not work. Not plugged in. 1. Important Safety Notes: The circuit breaker tripped or a fuse has blown. To reduce the risk of fire, electrical shock, or injury The bulb has burned out. Warnings The light button is “OFF”. when using your appliance, follow these basic Check to ensure that the Wine Cooler is precautions:...
- Page 5 Energy Saving Tips If the wine cooler is operated with R600a, flammable and explosive articles should not be put in or near the cabinet to avoid fire or The Wine Cooler should be located in the coolest area of the room, away from heat explosions.
- Page 6 Wring excess water out of the sponge or cloth when cleaning the area of controls, 2. Structure of Wine Coolers or any electrical parts. Wash the outside cabinet with warm water and a mild liquid detergent. Rinse well 1.USZ-54/USZ-72/USZ-128 /USZ-168 Series Structure Diagram: and wipe dry with a clean soft cloth.
- Page 7 NOTE: All parts removed must be saved to allow the door swing to be reversed. 2. USF-33S Series Structure Diagram: 1. Use sharp tools to carefully pry open the decoration nail on top of the cabinet and cap of the door spindle (Fig. 1).
- Page 8 3.USF-54S/USF-72S/USF-128S/USF-168S Series Structure Diagram: (1) Control panel (2) Active carbon filter (3) Ventilation fan (4) Sensor (6) Full wooden shelf (7) Small size wooden shelf (5) Sliding guide (8) Ventilation base (9) Adjustable feet (10) Latch hook hinge (11) Upper hinge (13) Door seal (12) Glass door...
- Page 9 Your cabinet was designed to store a maximum number of bottles safely. The wines are 4.USF-33D Series Structure Diagram: kindly advised to layout equally The best temperature for red wines is 10-18℃ (50-64°F) and 5-12℃ (41-50°F) for white wines. The temperature range of our wine coolers could be set between 5-18℃ (41-64°F) ◎...
- Page 10 5.USF-54D/USF-72D/USF-128D/USF-168D Series Structure Diagram: ◎ Wine Placement and Storage Several common wine layouts: (1) Control panel (2) Ventilation fan (3) Full wooden shelf (4) Sensor (5) Baffle plate (6) Active carbon filter (7) Ventilation fan (8) Sensor (9) Small size wooden shelf (10) Ventilation base (11) Adjustable feet (13) Upper hinge (14) Glass door (15) Door seal (12) Latch hook...
- Page 11 • ℃/℉ button: Celsius and Fahrenheit conversion button. 5. USF-168T Series Structure Diagram: • ON/OFF button: Power ON and OFF button. Note: This series of wine coolers has its delay protection function. The compressor will start to work about 3 to 5 minutes after it is powereed ON or OFF. Please use the wine cooler under the N type of climate.
- Page 12 ·UPPER CHAMBER: Display of the actual temperature of the upper chamber. The 3.Installation range is 0℃~37℃ or 32℉~99℉. Before Using your Wine Cooler ·LOWER CHAMBER: Display of the actual temperature of the lower chamber. The Remove the exterior and interior packing. range is 0℃~37℃...
- Page 13 4.3.Control Panel Below (Triple zone): 4. Operation Instruction 4.1 Control Panel Below ( Single Zone )： (Upper Control Panel) ◎ Display Windows ◎ Display Windows · RUN light: Indicator light of compressor working. When the compressor is in · RUN light: Indicator light of compressor working. When the compressor is in operation, the red light is ON and the red light is OFF when it stops operating.
- Page 14 ◎ Button Operation • SET button of the upper chamber: Temperature setting button. Once you press the button, the temperature increases to 1℃ or 1℉. The setting range is between 5℃ ~18℃ or 41℉~64℉. • SET button of the lower chamber: Temperature setting button. Once you press the button, the temperature increases to 1℃...
Need help?
Do you have a question about the USF-33S and is the answer not in the manual?
Questions and answers
My power on / off button doesn’t seem to turn the unit off. I don’t see any cords to unplug but because I don’t want to use it I just want it to power off.
If the power on/off button is not working, you can turn off the Eurodib USF-33S by unplugging it from the power socket. Ensure the unit is safely disconnected to avoid electrical hazards.
This answer is automatically generated
I have a 128-S i just purchased used with no manual, how do you lower the temp?
To lower the temperature on the Eurodib USF-33S, press the SET button for the desired chamber (upper or lower). Each press decreases the temperature by 1°C or 1°F within the range of 5°C to 18°C (41°F to 64°F).
This answer is automatically generated
可否自行添置倒挂酒杯架