Battery Installation/Removal; Recharging The Battery; Removing The Battery - Brother RJ-2030 Quick Setup Manual

Battery Installation/Removal

Installing the Battery (PA-BT-003)
1.
Move the battery cover lock to the unlock position, and then open the
battery cover.
2.
Insert the battery into the battery compartment until the battery latch
locks into place. Make sure that the terminal end of the battery is facing
inwards and oriented correctly as shown. Do NOT use excessive force
to install the battery.
1 Battery latch
3.
Close the battery cover, and then move the battery cover lock to the lock
position.

Removing the Battery

1.
Move the battery cover lock to the unlock position, and then open the
battery cover.
2.
While pushing the battery latch, remove the battery.
3.
Close the battery cover, and then move the battery cover lock to the lock
position.
1

Recharging the Battery

1.
Make sure that the rechargeable Li-ion battery is installed in your
printer.
2.
Use the compatible Brother AC adapter and AC power cord to connect
your printer to an AC power socket (see Recharging the Battery using
the AC Adapter (PA-AD-600) (Optional)), or use the Brother compatible
car adapter to connect your printer to a DC power socket (see
Recharging the Battery using the Car Adapter (Optional)).
3.
The LED indicator light is orange when the battery is charging.
When the rechargeable Li-ion battery is fully charged, the LED indicator
turns off (when power is turned off) or lights in green (when power is
turned on). Disconnect the AC adapter or car adapter from the battery's
DC connector.
For more information, see the User's Guide.
 Recharging the Battery using the AC Adapter (PA-AD-600) (Optional)
1.
Make sure that the rechargeable Li-ion battery is installed in your
printer.
2.
Open the interface cover and connect the AC adapter to your printer.
3.
Connect the AC power cord to the AC adapter.
4.
Connect the AC power cord to a nearby AC power socket
(100 - 240 VAC, 50 - 60 Hz).
1 AC adapter
2 AC power cord
 Recharging the Battery using the Car Adapter (Optional)
Connect your printer to your vehicle's 12 V DC power socket (cigarette lighter
or similar) to charge the rechargeable battery.
1.
Make sure that the rechargeable Li-ion battery is installed in your
printer.
2.
Connect the car adapter to the vehicle's 12 V DC power socket.
3.
Open the interface cover and connect the car adapter to your printer.
1 Car adapter
 Recharging the Battery using the Battery Charger (Optional)
The optional battery charger can also be used for charging the battery outside
of the printer. For more information, see the operation manual that is included
with the battery charger.
1
2
1