Service Guide I) Battery Troubleshooting Operation: Use the equipped hexagonal key to unlock the seat first, then use a Phillips screwdriver to open the battery compartment. Unplug the battery connector, then use a volt-meter to check the condition of the battery. Step (1) Release these four bolts Unlock position...
Page 4
Service Guide I) Check Battery Step (3) Unplug the battery connector (bigger white plug) Step (4)
Page 5
Service Guide I) Check Battery Step Reading Judgment: 25.5 V ~ 26.4 V – Good condition 22.5 V ~ 24.0 V – Recharge battery 21.5 V – Recharge battery. If after the stipulated recharging time, voltage has not increased, then the battery needs to be replaced. Below 19.2 V –...
Service Guide II) Wiring Troubleshooting Operation: There are three sets of connectors inside the battery compartment. Follow above Point (I) to remove the seat and battery cover, and then check the connections. Reverse above procedures to re-assemble the vehicle after checking.
Service Guide III) Check Chain Connection Operation: Tip over the vehicle, then follow below steps to access the chain and check the condition. Step (1) Unscrew to remove the bottom cover Step (2) Check to see if the chain is properly engaged Reverse above procedures to re-assemble the vehicle...
Service Guide IV) MCB (Motor Control Board) Replacement Operation: Follow Step (I) to remove and battery cover, and then unplug all three connectors to remove the MCB completely. Step (1) Step (2)
Page 9
Service Guide IV) MCB (Motor Control Board) Replacement Step (3) Unscrew that screw (needs only one screw) Step (4) Replace the whole MCB with a new/good one Re v erse above procedures to re-assemble the vehicle...
Service Guide V) Rear Caster Wheel Replacement Operation: Tip over the vehicle to take apart the Rear Caster Wheel for replacing. Step (1) You will need a wrench and a hex key to remove the caster wheels Step (2) Hexagonal key Wrench (13mm A/F)
Page 11
Service Guide V) Rear Caster Wheel Replacement Step (3) Unscrew the bolt and nut to remove the caster wheel Step (4) The replacement set includes one rolling wheel and two axle caps...
Service Guide VI) Front Wheel Replacement Operation: Follow below steps to take apart the Front Wheel. Step (1) There are five hexagon head screws to unfasten in order to remove the front wheel Step (2) Use the included hexagonal key to unscrew the five bolts from inner side...
Page 13
Service Guide VI) Front Wheel Replacement Step (3) Remove and replace a new front wheel from the front axle Step (4) Keep the bolts and nuts (5 sets) when replacing front wheel Reverse above procedures to re-assemble the vehicle...
Need help?
Do you have a question about the 24V Turnado and is the answer not in the manual?
Questions and answers