Controls - Philips AZ1007 Product Manual

CONTROLS

TOP AND FRONT PANEL
1 Source selector - to select source of sound:
CD-RADIO-TAPE and also the POWER OFF
switch.
2 VOLUME - to adjust volume level.
3 DBB - Dynamic Bass Boost: for a more vivid
bass response.
CASSETTE RECORDER:
4 PAUSE ; - to interrupt recording or playback.
STOP•OPEN 9 / - To stop the tape and to
open the cassette holder.
SEARCH 5 or 6 - to fast forward/rewind the
tape.
PLAY 1 - to start playback.
RECORD 0 - to start recording.
5 Cassette compartment
CD PLAYER:
6 CD Display - to show the CD functions.
7 PLAY•PAUSE 2; - To start or interrupt
CD play.
STOP 9 - to stop playback or erase a program.
Batteries
Whenever convenient, use the mains supply if you want to
conserve battery life. The battery supply will be switched off
when the set is connected to the mains. Make sure you remove the
plug from the set and wall outlet before inserting batteries.
Batteries (optional)
1. Open the battery compartment and insert six batteries, type
R20, UM1 or D-cells (preferably alkaline) with the correct
polarity as indicated by the (
compartment.
2. Replace the compartment door, making sure the batteries are
firmly and correctly in place. The set is now ready to operate.
– Incorrect use of batteries can cause electrolyte leakage and
will corrode the compartment or cause the batteries to burst.
Therefore:
– Do not mix battery types, e.g. alkaline with carbon zinc.
Only use batteries of the same type for the set.
– When inserting new batteries, do not try to mix old
batteries with the new ones.
– Remove the batteries if the set is not to be used for a long
time.
Batteries contain chemical substances, so they should be
disposed of properly
8
8 LIFT TO OPEN - to open/ close the CD door
RADIO:
9 BAND - to select FM/AM wave band
0 Tuning dial pointer
! TUNING - to tune to radio stations
BACK PANEL
@ Battery door - to open the battery
# BEAT CUT switch - To eliminate any whistle
$ Telescopic antenna - to improve FM
% p - 3.5 mm stereo headphone jacket
^ AC MAINS - inlet for mains cord
+ -
) and ( ) symbols inside the
POWER SUPPLY
CD MODE - to select a different play mode.
e.g. SHUFFLE/REPEAT; to program and review
programmed track numbers
SEARCH ∞ or § - to skip or search a
passage/ track backwards or forward
compartment
tones during AM recordings.
reception
Note: Connecting headphones will switch off the
loudspeakers
6x R20/UM 1/D-CELL