Regulatory Compliance Statements - Intel RES3TV360 Hardware User's Manual

Regulatory Compliance Statements

Federal Communications Commission Radio Frequency Interference Statement
Attention: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. However, if this equipment
does cause interference to radio or television equipment reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between equipment and receiver.
•
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/television technician for help.
•
Use a shielded and properly grounded I/O cable and power cable to ensure compliance of
this unit to the specified limits of the rules.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.
UL Compliance Statement
Special International Committee on Radio Interference Compliance Statement (CISPR 22)
Intel® RAID Expander Card RES3TV360 Hardware User's Guide
®
Intel products are are recognized under the Component Recognition Program of UL
to UL 60950-1 Second Edition and IEC-60950-1 Second Edition standards, file num-
bers E175975.
This product has been found to comply with the requirements of the Information Tech-
nology Equipment -- Radio Disturbance Characteristics -- Limits and Methods of
Measurement (CISPR 22).
iii