Advertisement
Connecting to the switch
A) Connect the supplied power adapter to the EWS switch and plug the other
end into an electrical outlet. Verify the power LED indicator is lit on the EWS
switch. Wait for the EWS switch to complete boot up. It might take few minutes
to complete the process.
B) Connect one end of a Category 5/6 Ethernet cable into the Gigabit
(10/100/1000) Ethernet port on the switch's front panel and the other end to
the Ethernet port on the computer. Verify that the LED on the Ethernet port of the
switch is green.
C) Connect the EWS access point(s) to the EWS switch. Verify that the LED on
the Ethernet port(s) of the EWS switch is green.
EnGenius Europe | Veldzigt 28, 3454 PW De Meern,
Netherlands | 0900-WIFIABC | www.wifiabc.com
EWS2910P-Kit-300
IP address configuration
A) Once your computer is on, configure
the setting of your network adapter.
Open 'Network Connections' >
Local Area Connection >
Internet Protocol Version 4 (TCP/IPv4) >
Properties.
B) Select 'Use the following IP address' and make
the following entries:
- IP address: 192.168.0.10 (or any address in
the 192.168.0.x network)
- Subnet mask: 255.255.255.0
Disclaimer: Information may be subject to changes without prior notification.
Quick Installation Guide
https://www.linkedin.com/company/engeniuseurope
https://twitter.com/engeniuseu
Follow us
https://plus.google.com/+EngeniusEuropeBVDeMeern
https://www.youtube.com/user/engeniuseuropebv
Advertisement
