Samsung HG32AB670BJXXZ Installation Manual page 19

✎
When the TV is on, connect the TV and the
y The RJP can be returned to the factory default settings by pressing the A/V and HDMI buttons simultaneously for 10
seconds. All LEDs blink 5 times to acknowledge that this has been finished.
y The RJP will automatically turn off any LEDs after 5 minutes to avoid unnecessary light pollution in the hotel room. The
LEDs that were turned off will turn on again if the guest touches any of the buttons and the 5 minute timer will restart. If the
guest then touches another source button, the TV will change to the selected source and the corresponding LED will be lit.
y After an RJP Reset or a TV Power OFF/ON, it takes approx. 10 seconds to establish communications between the TV and
the RJP.
y The following table shows the approximate time in seconds to switch from the TV to the input source, based on the
priority.
✎
Scenario 1: When no inputs are connected.
Source
AV
PC
HDMI
✎
Scenario 2: When two or more inputs are connected and an Input source is disconnected and then reconnected.
Source
AV
PC
HDMI
✎
E.g. If the RJP has all its live sources AV, PC and HDMI connected, AV is viewed as the highest priority. If the RJP is
in HDMI mode, and a guest removes and reconnects the AV, the minimum time required to switch to the AV is 6.5
seconds.
y To connect audio (Ipod or Mp3), Music mode should be ON and Jack Ident detect should be OFF.
y A/V, PC and HDMI input sources are supported.
RJP
To Connect
2 Sec
0.7 Sec
3.9 Sec
Disconnect To Connect
4.5 Sec
0.7 Sec 0.7 Sec
3.9 Sec 3.9 Sec
within 10 seconds.
Total
2 Sec 6.5 Sec
1.4 Sec
7.8 Sec
19
English