Control Panel; Drying - Bosch WTW83260GB Instruction Manual

rt the dryer if it is damaged!
ur after-sales service!
Make sure your hands are dry.
Only grasp the plug by the plug
body.
Remove all items from pockets,
especially cigarette lighters.
The drum must be empty prior to loading.
See also separate instructions for "Woollens basket"
(depending on model).
ector for setting
e and switching the appliance
turned in both directions.
programme individually
me selector / Off
Setting the drying time available only for timed programmes.
Fine adjustment of dryness level.
Setting the programme end.
Low-heat drying reduced temperature.
Extends the anti-crease function.
Buzzer on/off.
Starts, pauses and continues the programme; activates or deactivates
(Childproof lock).
Inspect the dryer
Connect the
mains plug
Sort the laundry
Set and adjust the
1
2
Close the door
Select
3
Start/Reload

Drying

Condensate

Control panel

container
with filter
Two-part
fluff filter
Air inlet
Drying
3
Empty the condensate container
Empty the container after each drying cycle,
but not during the cycle.
1.
Remove the container, holding it level.
2.
Pour out the condensate.
3.
Always push the container back in until it
7
clicks into place.
If (Condensate container) flashes in the
display panel despite the container having
been emptied clean filter in condensate
container, page 8/12.
Do not pull out/empty the condensate container
Door when drying is in progress.
Clean fluff filter
Clean fluff filters reduce energy consumption.
The fluff filter consists of two parts. Clean the inner and outer
filter after every drying cycle:
6
1. Open the door.
Remove fluff from the
door/door area.
2. Pull out both parts of
the fluff filter.
3. Remove fluff from the edge of the shaft.
Fluff should not fall into the open shaft.
4. Open the filter and
remove all the fluff.
5. Rinse both parts
under running water and dry thoroughly
6. Close the inner and outer filter, put them
back together and reinsert them into the
appliance.
5 Remove the laundry and switch off
the dryer
4
End of the programme...
Interrupt the programme
1. Open the door or press the Start/Reload button;
the drying cycle is interrupted.
2. Add or remove laundry and close the door.
3. If required, select a new programme and additional
functions. Select the Start/Reload button.
The remaining time is updated after a few minutes.
The drum and door may be hot!
4 4