Advertisement
O P E R A T I O N
To inf lat e t he King Dome
1 Place the base of the dome on a level surface.
2 Center the luminaire on the King Dome base. Verify that no part of the luminaire
can extend over the edge of the base during operation.
3 If you have not already done so, set the fixture operating mode and control
address.
4 Connect the luminaire's AC power lead to the 230 V (blue) or 110 V (yellow)
outlet on the King Dome base.
5 Lead the data cables through an air vent and connect them to the luminaire.
6 If the luminaire has a power switch, set it to the ON position. (Fixture power is
disabled until the King Dome is fully inflated.)
7 Fit the inflatable plastic dome over the base so that the Velcro strip on the
dome is right next to, and parallel with, the Velco strip on the base. Secure the
plastic dome by wrapping the double Velco tape over both Velcro strips.
8 Apply power to the King Dome.
The King Dome automatically inflates when power is applied. Power to the fixture
is enabled as soon as the King Dome is fully inflated,
To def lat e the King Dome
1 Extinguish the lamp by sending a lamp-off command from the controller.
2 Allow the luminaire to cool for at least 10 minutes, then disconnect the King
Dome from power.
3 Remove the double band of Velco that secures the plastic dome to the base.
4 Carefully fold and store the plastic dome.
5 Disconnect and remove the luminaire.
6 Remove the data cables and put everything away.
Advertisement
