Subscribe to Our Youtube Channel
Related Manuals for HunterDouglas POWERVIEW Motorization
Summary of Contents for HunterDouglas POWERVIEW Motorization
- Page 1 PowerView Motorization ™ SCENE CONTROLLER GUIDE © 2015 Hunter Douglas. All rights reserved. All trademarks used herein are the property of Hunter Douglas. 5110540082 5/15...
-
Page 2: Table Of Contents
Your new PowerView Pebble ™ ™ Scene Controller brings a Table of Contents new level of one-touch control to your Hunter Douglas Key Components....window coverings. It allows Getting Started. -
Page 3: Key Components
Key Components... - Page 4 POWERVIEW PEBBLE POWERVIEW SURFACE ™ ™ ™ SCENE CONTROLLER SCENE CONTROLLER Ergonomically designed, the hand-held PowerView The sleek PowerView Surface Scene Controller is wall- ™ ™ Pebble Scene Controller is available in seven on-trend mounted so it is always right where you left it. ™...
- Page 5 SCENE CONTROLLER SCENE CONTROLLER MODULE MODULE FRONT (BACK COVER REMOVED) OLED SCREEN Displays Scene names and Program menu FAVORITE SECOND FAVORITE SCENE Press to SCENE activate Press to activate BATTERY BATTERY COMPARTMENT COMPARTMENT 3V CR 2032 3V CR 2032 LEFT ARROW SELECT RIGHT ARROW For scrolling through...
-
Page 6: Getting Started
Getting Started... - Page 7 Getting started Mounting the PowerView Surface: ™ Choose a location to mount the Surface. First, activate the Scene Controller by pulling both plastic tabs from the back battery compartment. Orient the Surface mounting plate so that the Hunter Douglas logo is horizontal and level. Mark screw holes.
-
Page 8: Programming And Operation
Programming and Operation... - Page 9 Configuring the Scene Controller Check to be sure your PowerView Hub is powered up, ™ connected to a wireless router, and the light on the Hub is a solid blue. For INITIAL CONFIGURATION ONLY: press any button on the Scene Controller to activate controller. Screen should read: “Join Hub?”...
- Page 10 Updating Scene Name List in the Basic Operation Scene Controller To wake the Scene Controller, press any button. The last scene activated is displayed on the screen. Press and hold the “select” button for 4 seconds until the buttons begin to flash. This puts the Scene Controller To activate one of your FAVORITE Scenes, press ♥...
-
Page 11: Battery Replacement
Battery Replacement... - Page 12 Replacing batteries in the Scene Controller Rotate the back cover of the Scene Controller module clockwise to unlock. Replacing the batteries in the Scene Controller will not cause Remove the back cover from the Scene Controller the loss of any programming. The Scene Controller is powered module.
- Page 13 Using a finger or small Align and replace the back cover onto the backside of the Scene Controller module. screwdriver, gently lift and remove the Rotate the back cover counter-clockwise to old batteries. lock the back cover in place. Align the ribs on the Scene Controller module with the grooves on the Pebble ™...
-
Page 14: Troubleshooting
Troubleshooting... - Page 15 Troubleshooting I cannot get my Scene Controller to communicate with the Hub. There is nothing on the screen and none of the backlit buttons • Make sure the batteries in the Scene Controller are fresh, illuminate on my Scene Controller when I press the buttons. and that the Hub has a solid blue light.
- Page 16 PowerView ™ Scene Controller conforms with the essential requirements of the EMC directive 2004/108/ EC and R&TTE directive 1999/5/EC. A copy of the original declaration of conformity may be found at www.hunterdouglas.com/RFcertifications.
Need help?
Do you have a question about the POWERVIEW Motorization and is the answer not in the manual?
Questions and answers