Falcon E3900i User Instructions page 6

Code
Error
Communication
10
error
Initialisation
11
error
Current
12
reading failure
Mains
13 connection
error
Mains
14 connection
error
Coil electrical
15 circuit
self protected
6
Cause
Re-set required
Failure on LIN or CAN-Bus
Re-set required
Software failed when initialising
hardware
Re-set required
Generator detects that current
does not reflect what controls
require
Re-set required
Mains voltage is too high or
too low
Re-set required
Mains voltage is too high or
too low
Re-set required
Refer to Fault 04
Action
Switch unit off for 10 seconds, then on.
Engineer required.
Switch unit off for 10 seconds, then on
Wait. Generator will re-set every
30 seconds. Engineer required.
Switch unit off for 10 seconds, then on
Engineer required.
Switch unit off for 10 seconds, then on.
Engineer required.
Switch unit off for 10 seconds, then on.
Engineer required.
Switch unit off for 10 seconds, then on.
Refer to Fault 04.
U / E
User
Engineer
User
Engineer
User
Engineer
User
Engineer
User
Engineer
User
Engineer