Subscribe to Our Youtube Channel
Related Manuals for NTC vengio
Summary of Contents for NTC vengio
- Page 1 VENGIO’ WITH WALL IMAGE OPTION USER MANUAL NTC srl - Sales Office Manual Code UME-TVW01-05/16 www.newtableconcept.com All rights reserved...
-
Page 2: Table Of Contents
INTRODUCTION ___________________________________________________ 3 PACKAGE CONTENT _______________________________________________ 3 REQUIRED TOOLS _________________________________________________ 3 WARNINGS _______________________________________________________ 4 UNPACKING ______________________________________________________ 4 PREPARE VENGIO’ FOR ASSEMBLY __________________________________ 5 ASSEMBLY _______________________________________________________ 7 OPENING AND CLOSING ___________________________________________ 10 CLEANING AND MAINTENAINCE ____________________________________ 11 10. WARRANTY _____________________________________________________ 11 UME-TVW01-05/16 www.newtableconcept.com... -
Page 3: Introduction
Dear Customer, thank you for choosing the VENGIO’ folding table! The VENGIO’ folding table is built with high quality materials and extensive attention to detail. The compact "Counter Weight System" (CWS) is the NTC srl exclusively patented marvel, which ensures everlasting functionality and beauty. -
Page 4: Warnings
The NTC srl ensures the robustness of the table, but is not responsible for any failure due to the wall or to an insufficient mounting to the wall itself. -
Page 5: Prepare Vengio' For Assembly
Fig. 11 Fig. 12 6. PREPARE VENGIO’ FOR ASSEMBLY The table is shipped assembled and, to mount it on the wall, it is necessary to partially disassemble it. Figure 13 shows the table parts that will be referenced later in this manual. - Page 6 Fig 13 A - mounting plate B - springs cover C - springs compartment D - table frame E - table top F - legs module 1. Place the Vengiò table on a bench (Fig. 14) and remove the packing material. 2.
-
Page 7: Assembly
7. ASSEMBLY Determine the location and make sure the wall can adequately support the table and the stress that it will be exposed to. The wall should be flat, free from any obstacles (sockets, air intakes, etc.) and at least 240 cm (95”) high. Place the holes template in the desired position (Fig 18). - Page 8 under the springs cover (Fig. 25). 12 Screw the three lower screws of the mounting plate without tightening them. Pay attention not to scratch the frame. 13 Place a piece of foam of the packaging in the middle of the spring cover (Fig. 26). The piece of foam will protect the spring cover against scratches during the table top assembly.
- Page 9 18 Open the table and assemble the legs module. Fix the legs module to the table top with the two M6 cylindrical screws (Fig. 31 and Fig 32). Fig. 31 Fig. 32 19 With the table open, remove the piece of foam and the wooden spacer (Fig. 33). 20 Make sure both legs touch the floor by rotating the table around the top central screw of the mounting plate (Fig.
-
Page 10: Opening And Closing
24 Position the panel with the wall image on the table and unpack it. Use the packaging material to protect the table while drilling the two holes (Fig. 38). Remove the wall image assembly bar from the back of the panel simply sliding sideway (it is attached magnetically to the panel). 25 Drill the two holes to fix the wall image bar (Fig. -
Page 11: Cleaning And Maintenaince
The broken parts will be replaced free of charge. The shipping expenses will be charged to the customer. To make a claim under the warranty, send an e-mail to support@newtableconcept.com with a description and pictures of the defect. NTC srl reserves the right to modify the product without any notice. UME-TVW01-05/16 www.newtableconcept.com Page 11...
Need help?
Do you have a question about the vengio and is the answer not in the manual?
Questions and answers