Panasonic NV-GS320EG Service Manual page 40

Service Manual
Diagrams and Replacement
Parts List
Digital Video Camera/Recorder
Model No.
NV-GS320EG NV-GS320GC
NV-GS320E NV-GS320GN
NV-GS320EB NV-GS320SG
NV-GS320EP NV-GS320PL
NV-GS320EE NV-GS320GT
NV-GS320EF NV-GS328GK
NV-GS320EK
Vol. 1
Colour
(S)...........Silver Type
Table of contents
S1. About Indication of The Schematic Diagram ............................ S-1
S1.1. Important Safety Notice......................................................... S-1
S2. Voltage Chart ........................................................................... S-2
S2.1. Monitor P.C.B. ....................................................................... S-2
S2.2. Front P.C.B. ........................................................................... S-2
S2.3. EVF P.C.B. ............................................................................ S-2
S3. Block Diagram .......................................................................... S-3
S3.1. Overall Block Diagram .......................................................... S-3
S4. Schematic Diagram .................................................................. S-4
S4.1. Interconnection Diagram ....................................................... S-4
S4.2. Monitor Schematic Diagram .................................................. S-5
S4.3. Front Schematic Diagram ..................................................... S-6
S4.4. EVF Schematic Diagram ....................................................... S-7
S4.5. CCD Flex Schematic Diagram .............................................. S-8
S5. Print Circuit Board .................................................................... S-9
S5.1. Monitor P.C.B. ....................................................................... S-9
VM0701006CE
S1. About Indication of The Schematic Diagram
S1.1. Important Safety Notice
COMPONENTS IDENTIFIED WITH THE MARK
FOR SAFETY. WHEN REPLACING ANY OF THESE COMPONENTS USE ONLY THE SAME TYPE.
1.Although reference number of the parts is indicated on the P.C.B. drawing and/or
schematic diagrams, it is NOT mounted on the P.C.B. when it is displayed with "$" mark.
2.It is only the "Test Round" and no terminal (Pin) is available on the P.C.B.
when the TP (Test Point) indicated as "
3.The voltage being indicated on the schematic diagram is measured in
"Standard-Playback" mode when there is no specify mode is mentioned.
4.Although the voltage and waveform available on here is measured with standard frame,
it may be differ from actual measurement due to modification of circuit and so on.
5.The voltage being indicated here may be include observational-error (deviation) due to
internal-resistance and/or reactance of equipment. Therefore, handle the value
indicated on here as reference.
6.Use the parts number indicated on the Replacement Parts List .
7.Indication on Schematic diagrams:
S5.2. Front P.C.B. ......................................................................... S-10
S5.3. EVF P.C.B. .......................................................................... S-10
S5.4. CCD Flex P.C.B. .................................................................. S-11
S6. Replacement Parts List .......................................................... S-13
S7. Exploded View ....................................................................... S-19
S7.1. Frame and Casing Section (1) ............................................ S-19
S7.2. Frame and Casing Section (2) ............................................ S-20
S7.3. LCD Section ........................................................................ S-21
S7.4. Camera Lens Section.......................................................... S-22
S7.5. Video Mechanism Section ................................................... S-23
S7.6. Packing Parts and Accessories Section .............................. S-24
S-1
" mark.
Circuit name being connected.
This signal is connected
OFTR FEP
to the FEP schematic diagram.
Name of Signal
HAVE THE SPECIAL CHARACTERISTICS