Table of Contents
Advertisement
Available languages
Available languages
Care and Maintenance
CLEANING THE APPLIANCE
•
Turn the temperature control to the "OFF" or "0" position, unplug the unit and remove the food and interior accesso-
ries.
•
Wash the inside with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking
soda to a quart of water.
•
Wash the baskets and interior accessories with a mild detergent solution.
•
The outside of the unit should be cleaned with mild detergent and warm water.
Caution: Failure to unplug the appliance could result in electrical shock or personal injury.
Troubleshooting
Occasionally, a minor problem may arise, and a service call may not be necessary - use this troubleshooting guide for
a possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby's Toll Free
Number for assistance.
PROBLEM
Does not work
Refrigerator runs continuously
Internal temperature not cold
enough
Tel: 1-800-26-
POSSIBLE CAUSE
•
No power to unit
•
Power cord is unplugged
•
Wrong voltage is being used
•
Temperature set too low (too
cold)
•
Door is not closed
•
Hot food inserted
•
Door opened too long or too
often
•
Close proximity to heat
source or direct sunlight
•
No power to unit
•
Power cord is unplugged
•
Temperature control set too
high (too warm)
•
Door is not closed
•
Hot food inserted
•
Door opened too long or too
often
•
Air fl ow obstruction
•
Wrong voltage is being used
•
Close proximity to heat
source or direct sunlight
4
(1-800-263-2629)
•
Check connection of power
cord to power source
•
Plug in the unit
•
Use proper voltage
•
Set temperature higher
(warmer)
•
Close door securely
•
Be sure food is at room tem-
perature before inserting
•
Minimize door openings/du-
ration
•
Do not place unit close to
heat sources or direct sun-
light
•
Check connection of power
cord to power source
•
Plug in unit
•
Check setting and change as
needed
•
Close door securely
•
Be sure that food is at room
temperature
•
Minimize door openings/du-
ration
•
Allow room for air to circulate
around the unit
•
Use proper voltage
•
Do not place unit close to
heat sources or direct sun-
light
SOLUTION
Advertisement
Table of Contents
