Suzuki SQ416 Service Manual page 98

1B-24 AIR CONDITIONING (OPTIONAL)
1. A / C condenser assembly
2. Receiver / Dryer
DESICCANT (IF RECEIVER/DRYER IS INTEGRATED
WITH CONDENSER)
REMOVAL
1) Remove A/C condenser assembly from vehicle. Refer to "Con-
denser" in this section for detail.
2) Remove receiver/dryer cap from condenser.
3) Remove filter from receiver/dryer.
4) Remove desiccant using plier.
1. Desiccant
2. Plier
INSTALLATION
Reverse removal sequence to install desiccant referring to the fol-
lowing notes.
NOTE:
D Add 40 cm
sor manufacturer shown on its label when replace desiccant.
D Do not open plastic bag until just before installing it into receiv-
1. Desiccant
er/dryer.
2. Clinch
D Install desiccant with its clinch facing to bottom of receiver/dryer.
3. Receiver / Dryer
FILTER ELEMENT
REMOVAL
1) Disconnect negative cable at battery.
2) For vehicle with air bag system, disable air bag system. Refer
to DISABLING AIR BAG SYSTEM in section 10B.
3) Pull down glove box.
1. Glove box
2
(40 cc) of compressor oil recommended by compres-