Computer Configuration; Connect To Wireless Network - M-Life ML0585-N Owner's Manual

Cautions:
1. Disconnect the device during thunderstorms in case of lightning damage.
2. Keep far from heat source and ensure proper ventilation.
3. Keep waterproof in the storage, transportation and operating environments

1. Computer Configuration

Click Start→Control Panel→Network and Internet→Network and Sharing
1.
Center→Change adapter settings→Wi-Fi(right click)→Properties.
2. Double click Internet Protocol Version 4(TCP/IPv4).
3. To set up the computer IP 192.168.2.x (x arbitrary integer between 2~252), subnet
mask of 255.255.255.0, gate of 192.168.2.1 and click OK. Back to the last interface
and click OK.

2. Connect To Wireless Network

1. Plug the Wi-Fi Repeater to a wall socket.
2. Click on the network icon
desktop. You will find the signal from the Wi-Fi Repeater. Click
on Connect and wait few seconds.
3. When shows: Connect to a Network, please click Connect to
the network without setting it up.
EN
4. Open web browser and type http://192.168.2.1 in the browser's address box. This
number is the default IP address for this devices.
NOTE! If you cannot load http://192.168.2.1, please check whether Wi-Fi repeater
is on default settings. If not, or if you cannot verify the reason for lack of connection,
restore default settings. Press the reset button for 3-5 seconds and try to install it
again.
14
Owner's manual
on the right bottom of your