Getting Started; Step 1: Inserting Batteries Into The Remote Control; Using The Remote Control To Operate The System; Step 2: Switching On The Dvd System - Philips HTS3300 User Manual

Getting Started

Step 1: Inserting batteries into
the remote control
3
1
2
1
Open the battery compartment.
2
Insert two batteries type R06 or AA,
following the indications (+-) inside
the compartment.
3
Close the cover.
CAUTION!
– Remove batteries if they are
exhausted or if the remote control
is not to be used for a long time.
– Do not use old and new, or
different types of batteries in
combination.
– Batteries contain hazardous
chemical substances, so they should
be disposed of properly.
Using the remote control to
operate the system
1
Aim the remote control directly at the
remote sensor (iR) on the front panel.
2
Select the source you wish to control by
pressing one of the source select buttons
on the remote control (for example TV,
TUNER).
3
Then select the desired function (for
example É, S, T).
16
Step 2: Switching on the
DVD system
G
Press the SOURCE control to select :
DISC ™ FM ™ MW ™ TV ™ AUX
™ DISC ....
OR
Press DISC, TV, TUNER or AUX/DI on
the remote.
Switching to Eco Power standby
mode
G
Press STANDBY ON (B).
➜
The display screen will go blank.

Step 3: Setting the TV

After connecting the DVD system to
your TV, you have to switch the TV to the
correct programme number for the input
socket (e.g. 'EXT', '0', 'AV') in order to
view the playback from the DVD system.
1
Press SOURCE control until "DISC"
appears on the display panel.
2
Turn on the TV and set it to the correct
video-in channel. You should see the blue
DVD background screen on the TV.
➜
Usually this channel is between the
lowest and highest channels and may be
called FRONT, A/V IN, VIDEO. See your
TV manual for more details.
➜
Or, you may go to channel 1 on your
TV, then press the Channel down button
repeatedly until you see the Video In
channel.
➜
Or, the TV remote control may have a
button or switch that chooses between
different video modes.
3139 115 2xxx1