Advertisement
NOTE: Even though the protection circuit engages. a spark may occur due to
the improper connection. In the event of this happening the jump start cable
will need to be replaced prior to attempting to jump start a vehicle again.
The unit will continue to function in charging and flashlight modes.
NOTE: Contact customer service to acquire a new jump start cable. Improper
connections are not covered by the units warranty and the replacement cost
will be the customer's responsibility.
Q: How many times can the unit jump start a vehicle?
A: The unit will average up to 15-20 jump starts on a single charge
Q: How long will the unit hold a charge in standby mode?
A: In standby mode, the unit will hold a charge for approximately 3 - 6 months.
We recommend charging the unit every 3 months to prolong service life.
-Safety Warnings
li\ Failure to obey the safety warnings may result in fire. electronic shock
~and damage to your vehicle.
1. Do NOT throw or apply strong physical shocks to the product and NEVER
attempt to disassemble or puncture the product. Keep the product away from
fire, heat and water. You are required to use our specified AC adapter charger
I DC charger to charge the product. If the product appears abnormal in
shape, immediately stop operation.
2. Keep the product away from children, unit is NOT a toy for kids to play with.
3. Never allow clamps to touch each other or to contact the same piece of metal
to prevent sparking.
Trouble St1ooting
I
Problem
II
Cause
II
Solution
When charging, the 5 battery
If the unit has not been used for an
Disconnect the USB charging cable
charge level indicator lights are
extended period of
time,
it is in
and reconnect it to the unit. This
illuminated. but the unit is NOT
power save mode and at
should reinitialize the charging
fully charged
approximately 60% charge.
procedure and the unit should
begin recharging.
The unit does not respond when
The charge level of the unit is below
Connect the charging cable to the
pressing the power button.
operating levels and the "low voltage
unit to
begin
the recharge process
protection" circuit has engaged.
and
reactivate the
unit.
Advertisement
