Advertisement
LED Light
{3 Illumination Modes)
To activate the LED light, press and hold the power button for 3 seconds after
which it will illuminate solid ON. Press and release the power button to cycle to
strobe mode and once again for S.O.S. mode. Press and release the power
button to continue cycling through the three illumination modes or hold the
power button for 3 seconds to turn the LED light OFF
How tc) Jurn1J
,start
a
V'e~hicle~
1. Make sure the remaining battery capacity of the unit is above 60% (there
should be at least 3 indicator lights illuminated);
2. Connect the jump start cable to the drained or dead battery of the vehicle,
with the red clamp to battery"+", black clamp to battery"-";
3. Connect the jump start cable to the unit (just plug the end of the jump
start cable into the "Jump Start Socket");
4. You can now crank the engine. If engine does not start, wait at least 10
seconds before attempting to start the vehicle again;
5. Disconnect the jump start cable immediately from the unit (within 20
seconds)
after the vehicle engine has being successfully started. Then
remove the clamps from the battery terminals.
A
To prevent sparking, never allow clamps to touch each other or to
· contact to the same piece of metal .
Frequently Asked Questions
Q: What are the main features of this product?
A: This unit is designed to charge most mobile electronic devices that require
5V DC for charging via a micro-USB connection. It is also equipped with a
bright LED light with 3 illumination modes as well as the unique ability to jump
start your vehicles engine in the event of a dead or drained battery.
Q: Does the unit need to be turned OFF after charging?
A: No. The unit features an auto-off function once fully charged.
Q: How long will it take to fully charge the unit?
A: About 3 hours
Q: Will a "Reverse Polarity Connection" damage my vehicle?
A: No. Our unit is designed with a built-in protection circuit making it safe to
use. If an improper connection is made while attempting to jump start a vehicle,
the protection circuit will activate and cut power output immediately.
Advertisement
