Advertisement
S T E P 4
Remove the back of the sensor by Pushing in the oval button at the top of the device, releasing the back from
1
the unit.
Insert the included battery, noting the correct + and - polarity.
2
Tap the "Add Sensor" icon on the Almond touchscreen and press the "Add" button on the screen.
3
4
Now tap and quickly release the sensor's "Join/Reset" button as shown and the sensor should be added to your
Almond. The LED will flash to indicate that the sensor is being added.
Reattach the rear cover of the sensor and make sure it snaps in place properly.
5
On the Almond touchscreen, return to the "Home" screen, tap the "Connected Sensors" icon, and tap the
6
sensor you've just added. Press the "Tampered" button to reset the tamper switch. Your sensor should now be
fully operational and ready to be installed at your location of choice.
S T E P 5
Remove the back of the sensor by pushing
1
in the button at the bottom of the sensor.
Insert the battery.
2
Tap on the "Add Sensors" icon in the LCD
3
UI of your Almond and tap on "Add" to
start adding the sensor.
Setting up the door/window sensors
Zigbee
Hue
Battery
Setting up the Motion Sensor
Add Sensors
Add
Remove
Remove all Sensors
Tamper switch
Join/Reset button
LED indicator
Adding Sensor...
Please wait
Advertisement
