Battery Removal - Remington PF7400 Instructions Manual

ENGLISH
• Lubricate the teeth of the trimmer every six weeks with a drop of sewing
machine oil.
, Note: the shaver headguard has been designed so that when placed on the
shaver head, the shaver can be stood on the headguard to allow any water
droplets to drain from the shaver head.
, REPLACING THE FOILS & CUTTERS
• To ensure continued high quality performance from your shaver, we
recommend the foils and cutters are replaced regularly.
, Signs that your foil/s and cutter/s need replacing
• Irritation: as foils get worn, you may experience skin irritation.
• Pulling: as the cutters wear, your shave may not feel as close and you may
feel the cutter pulling your hair.
• Wear through: you may notice that the cutters have worn through the foils.
, TO REPLACE THE FOIL
• Pull the foil assembly up to remove from the hair pocket.
• Insert the new foil assembly on the hair pocket, press down and
click into place.
, REPLACING THE CUTTERS
• Grasp the cutter between your thumb and forefinger and pull upwards.
• Snap the new cutter into the oscillator tip.
, Note: DO NOT press on the cutter ends as this may cause damage.
• Foil and cutters replacement model: SPF-PF

BATTERY REMOVAL

• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing
the battery.
• Remove 2 screws from the end cap. Remove the end cap and main housing
from the back.
• Using a small screwdriver, pry off the rear housing.
• Remove 6 screws and then open the inner cover from the shaver to expose
the battery.
• Cut the tabs which connect the battery to the circuit board and remove the
battery.
• Dispose of the battery safely.
6