Thank you for purchasing this Macrom product. Should your product need warranty service, please return it to the shop where you buy it or to the Macrom distributor in your country. The warranty does not cover damage due to improper use and or installation, incorrect connections to power supply and audio sources, exposure to excessive humidity, unauthorized repair attempts or modifications.
Product overview Front Panel 1. Power DC connector 2. Fuse [20A] POWER IN M-DSPA.401 BATT FUSE 3. Subwoofer output (20A) 4. Front output 5. Rear Output 6. Speakers connector 7. LED power indicator 8. LED effect indicator POWER EFFECT 9. ON/OFF effect swict...
3. Turn ON Bluethooth on your mobile and search "M-DSPA.401", then PAIR it. If requiredt the pairing code is :1234. 4. Open the APP "M-DSPA.401" and click [ Connect ], then you will connect to the amplifier and you can set your own sound by the APP.
APP overview Main 1. Parametric Equalizer; click on it to obtain the EQ functions. 2. Time Alignment; click on it to obtain the TA functions. 3. Setting; click on it to obtain the setting functions. 4. Favorite preset; you can load the 5 favorite setting saved in the amplifier. 5.
APP overview Crossover filter 1. Front graphic view 2. Front low pass frequencies setting, adjustable from 20Hz to 20.000Hz 3. Front low pass slope, selecatble from 6-12-18-24/dB or Bypass 4. Rear graphic view 5. Rear low pass frequencies setting, adjustable from 20Hz to 20.000Hz 6.
APP overview Setting channels 1. FR-Gain adjustable from -90 to +5 2. FR-Phase switch from 0° to 180° 3. RR-Gain adjustable from -90 to +5 4. RR-Phase switch from 0° to 180° 5. SW - Selector phase adjustable from 0 ° to 180 °. 6.
APP overview Time alignment 1. Increase (+) front right speaker delay. 2. Decrease (-) front right speaker delay. 3. FR - adjustable delay Viewer from 0 cm to 230 cm. 4. Increase (+) Right rear speaker delay. 5. Decrease (-) late stage right rear speaker. 6.
APP overview Selector gain level 1. Cancel, selection cancel. 2. Type the value for the level between -90 to + 5dB. 3. Cursor to change the value of the level. 4. OK, press to confirm the selection. Selector frequency cuts 1.
1. Plug & Play. Interpose the Plug & Play wiring between the Car Stereo and the connector coming from the vehicle and connect the ends to ‘M-DSPA.401 amplifier. Note: check the available wiring on www. macrom.it 2. OPTIONAL: For more power and sound quality you can proceed with a power upgrade as shown in the diagram.
Connections 1 System Extension Thanks to the pre-amplified outputs on the product you can expand the system by adding a powered subwoofer. Uscita remota (+12V ) Subwoofer BATT +12V Ground (Telaio) Car Stereo 2 System Extension Thanks to the pre-amplified outputs on the product you can expand the system by adding a multi-channel amplifier (4 + 1) to enhance the sound system.
Declaration of Conformity M-DSPA.401 DSP POWER AMPLIFIER Hereby, Aldinet S.p.A, declares that this type of M-DSPA.401, Brand Macrom is in compliance with the essential requirements and other relevant provisions of Directive R&TTE 1999/5/EC. The Declaration of Conformity is available at: Aldinet S.p.A.