Table of Contents
Advertisement
How to Use the Mini-Quick Cycle
The MINI-QUICK cycle is a
short cycle, intended to wash
clothes you need
The Mini-Basket tub should be
used for satisfactory results.
1.
Follow steps 1 through 9
on previous page except
for cycle selection.
How to Use the Soak Cycle
Soak Cycle temperature
is controlled by the
selection.
For a warm soak,
set
the WasMRinse Temp.
control to HOT~ARM.
For a hot soak,
set the WasMRinse Temp. control
to HOT~ARM and turn the Cycle Selector knob to
NORMAL in the Regular Cycles.
Be sure the Extra Rinse control is set at OFF.
If your clothes and household
items don't look clean and fresh
after washing, you will probably
rewash them.. and that means
you'll waste energy. Remember to
sort your clothes carefully, and
load them properly, select correct
cycles, use enough detergent and
choose a water temperature warm
enough to release and get rid
of soil.
Use Hot Wash—up to 150°F.
articles-such as work and
play clothes.
12
(continued)
2.
Push the Cycle Selector knob in
and turn it clockwise to the
MINI-QUICK cycle.
3.
Pull the Cycle Selector knob out
to start the washer.
Start the washer. After washer fills and begins to
agitate, push in the Cycle Selector knob and turn to
SOAK CYCLE. Pull out the Cycle Selector knob to
complete the cycle.
For an extended soak,
agitate for a few minutes to dissolve the soaking
agent. Then push in the Cycle Selector knob to stop
the washer (keep lid closed) and allow to soak for
as long as desired. After desired soak period, pull
out the Cycle Selector knob to complete the cycle.
Do not use the Fabric Softener Dispenser or the
Mini-Basket tub with the Soak Cycle.
Under normal soil conditions,
wash in water above 80°F.
using the Warm Wash
temperature setting on your
washer—temperatures
approximately 90°F.–l 10°F.
comfortable. If you notice that
soil has accumulated after several
consecutive washings, use Hot
Wash occasionally, if safe
for fabrics.
Always rinse in cold water. The
temperature of the rinse does not
affect cleaning.
Try to wash less often. Save
articles of the same type of fabric
until you have a full load.
.
NORMAL
allow the washer to fill and
If you must wash smaller loads,
adjust the amount of water.
Small loads should have lower
water levels.
Wash in off-peak utility hours.
Your local utility can tell you
which are the off-peak hours.
Use Normal Spin Speed to
remove more water and help
lessen drying time. The dryer
will remove any wrinkles caused
by the Normal Spin.
Use your Mini-Basket tub for
very small loads. It uses less
water than the small water level
in the big tub on this washer.
You will also save on detergent
and energy.
Advertisement
Table of Contents
