Mitsubishi Electric MR-CU375S-W-A Service Manual page 18

OPERATING PROCEDURE
3. Detachment the Vegetable case parts
(1) Detach parts inside vegetable compartment (Vegetable case, Fruit case).
(2) Detach the door of vegetable compartment.
(3) Detach rivet (F) at the right and unhooking 2 catch at front,
(center and left). (Photo 5)
Caution on assembly
Be sure to put vegetable case cover on the catches at the rear of
vegetable compartment.
Water pump motor
(4) Remove two screws and cut the lead wire of water-pump motor to
detach it.
4. Detach the refrigerator room parts
(1) Detach parts inside the refrigerator compartment.
(See procedure (2))
(2) Detach parts inside the vegetable compartment.
(See procedure (3))
(3) Detach a left screw of mirror hinge and pull out the lead wire.
(Photo 7)
(4) Detach the connector.
Control panel ,Duct R, Temperature control panel
(5) Remove the upper and lower rivets (F) of right side and unhook 6 catches.
* Remove the right catch before push the control panel to the right
and detach it. (Photo 7)
Fan grille
(6) Remove the following; Screw (A) at the upper and right center,
2 screws (B) at the left and 2 screws (B) at the right.
* Motor damper and thermal fuse are combined with fan grille.
* Fan and fan motor are combined with fan grille.
Caution on assembly
(1) Use new tapes and sealing materials for assembly.
(2) Putting some tape across joints, tape them securely so that they will
not leak the cool air.
(3) Attach a connector securely in order to prevent contact failure.
Photo 5
Photo 6
Screw
Photo 7
Catch
Catch
- 17 -
PHOTOS
Catches
Catch
Catch
Vegetable cave
Vegetable cave
cover
Fan grille
F-room
Catch Catch
Catch
Rivet
Lamp
Control panel
Screw
Mirror hinge
Screw
Fan grille
Catch
Rivet
Screw
Catch
Screw