Jumper Details For Nio Card - C-DOT DSS MAX Installation And User Manual

Chapter 3.
Jumper Status
W13 (1-2) Short
W13 (2-3) Short
W14 Short
W14 Open
W15 Short
W15 Open
Note: Position of jumper W5, W10 and W11 decide the level 2 or level 4 operation of NSE.
* Other jumper settings may be left as per factory default settings as shown.
3.4.

JUMPER DETAILS FOR NIO CARD

Jumper
W1
W2
W3
Note : Position of jumpers W6, W7, W8 on NCP card and W2, W1 and W3 on NIO
card decide whether a reference trunk is selected or reference clock is selected by
NSE.
14
To get 2 MHz Clock O/P at connector J6
To get 16 MHz Clock O/P at connector J6
If PSI is mounted
If PS2 is mounted
If PS2 is mounted
If PS1 is mounted
Status
To connect Ref-Trk1 (G.703/6) to phase
Short
detector
Open To connect reference clk 1 to phase detector
To connect Ref-Trk0 (G.703/6) to phase
Short
detector
Open To connect reference clk 0 to phase detector
To connect Ref-Trk2 (G.703/6) to Phase
Short
Detector
Open To connect reference clk 2 to phase detector
Function
Function
C-DOT NSE