Table of Contents
Advertisement
Assembling and mounting the wall mount unit
&
Securely fasten the upper and lower wall-side
fittings to the middle wall-side fitting with the
four supplied M4 screws.
é
Fasten the unit with commercial anchors or the
four screws. Be sure that the anchors or
screws are fastened at a position where there
is a post.
Note:
Use anchors and screws to suit the various wall
types. The enclosed template can be used for
general positioning only.
Mounting the plasma display
&
Mount the display (to which the display fittings
have already been attached) to the wall
mounting unit.
é
Fit the upper hooks of the display fittings into
the grooves of the (upper) wall fittings and
adjust for level positioning.
Note: It is recommended that the power cable and
various signal cables be plugged into the display
before mounting the display. After mounting the
display, plugging in the cables may be difficult.
If the display is tilted to the left or right, the
display fitting is not properly placed on the wall
mounting unit. Slide in the direction of the
lower side and adjust for level positioning.
Make sure that the wall mount unit is being
fixed securely enough so that it meets safety
standards.
"
Anchor the plasma display.
Align the thumb screw, which is located at the
bottom of the display fitting, with the hole of
the (lower) wall-side fitting and tighten to
anchor.
Fasten securely until the screw ceases to turn.
To remove the display, loosen the thumb
screws until they come out of the hole.
Pull the bottom portion of the display towards
you and lift upward to release the display.
CAUTION
Firmly support the display when mounting it.
Failure to do so may result in the plasma display
falling and causing injury.
5
5
Advertisement
Table of Contents
