Table of Contents
Advertisement
*1
Only when a graphic accelator board that is capable of displaying 852 x 480.
*2
This signal is converted to a 1228 dots x 768 lines signal.
*3
The picture is displayed in the original resolution.
*4
The aspect ratio is 5:4.This signal is converted to a 960 dot x 768 line signal.
*5
Normally the RGB select mode suite for the input signals is set automatically.
If the picture is not displayed properly, set the RGB mode prepared for the input signals listed in
the table.
*6
Other screen modes (ZOOM and STADIUM) are available as well.
*7
When viewing a moving picture at a vertical frequency greater than 65Hz, the picture may
sometimes be unstable (jumpy). If this occurs, please set the refresh rate of the external
equipment to 60Hz.
To view 480i@60Hz (480 interlaced lines, 60Hz refresh rate) or 576i@50Hz (576 interlaced
lines, 50Hz refresh rate) when sync polarity is 'Sync on Green', set 'RGB SELECT' to 'MOTION'.
What is HDCP technology?
HDCP is an acronym for High-bandwidth Digital Content Protection. High bandwidth Digital Content
Protection (HDCP) is a system for preventing illegal copying of video data sent over a Digital Visual
Interface (DVI).
If you are unable to view material via the DVI input, this does not necessarily mean the PDP is not
functioning properly.With the implementation of HDCP, there may be cases in which certain content
is protected with HDCP and might not be displayed due to the decision/intention of the HDCP
community (Digital Protection, LLC).
Note:
• While the input signals comply with the resolution listed in the table above, you may have to adjust the
position and size of the picture or the fine picture because of errors in synchronization of your computer.
• When a 1280 dot x 1024 line signal or 1600 dot x 1200 line signal is input to the monitor, the picture will
be compressed.
• This monitor has a resolution of 1365 dot x 768 line. It is recommended that the input signal should be
XGA, wide XGA, or equivalent.
• With digital input some signals are not accepted.
• The sync may be disturbed when a nonstandard signal other than the aforementioned is input.
• If you are connecting a composite sync signal, use the HD terminal.
*"IBM PC/AT" and "VGA" are registered trademarks of IBM, Inc. of the United States.
FCC Compliance notice
This equipment has been tested and found to comply with the limits for a Class B equipment,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which case
the user will be required to correct the interference at his own expense.
20
Advertisement
Table of Contents
