Troubleshooting - Philips FWM205 User Manual

10 Troubleshooting

Warning
•
Never remove the casing of this product.
To keep the warranty valid, never try to repair
the product yourself.
If you encounter problems when using this
product, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page
(www.philips.com/support). When you contact
Philips, make sure that the product is nearby
and the model number and serial number are
available.
No power
•
Ensure that the AC power plug of the unit
is connected properly.
•
Ensure that there is power at the AC
outlet.
•
To save power, the system switches off
automatically 15 minutes after track
play reaches the end and no control is
operated.
No sound or poor sound
•
Adjust the volume.
•
Check that the speakers are connected
correctly.
•
Check if the stripped speaker wires are
clamped.
No response from the Hi-Fi system
• Disconnect and reconnect the AC power
plug, then turn on the system again.
•
As a power-saving feature, the unit
switches off automatically 15 minutes after
track play reaches the end and no control
is operated.
Remote control does not work
• Before you press any function button, first
select the correct source with the remote
control instead of the main unit.
EN
15
•
Reduce the distance between the remote
control and the unit.
• Insert the battery with its polarities (+/–
signs) aligned as indicated.
•
Replace the battery.
•
Aim the remote control directly at the
sensor on the front of the unit.
No disc detected
•
Insert a disc.
• Check if the disc is inserted upside down.
•
Wait until the moisture condensation at
the lens has cleared.
•
Replace or clean the disc.
•
Use a finalized CD or correct format disc.
Poor radio reception
•
Increase the distance between the unit and
your TV or VCR.
•
Fully extend the FM antenna.
Alarm does not work
•
Set the clock/alarm correctly.
Clock/alarm setting erased
• Power has been interrupted or the power
plug has been disconnected.
•
Reset the clock/alarm.
USB device not supported
•
The USB device is incompatible with the
unit. Try another one.