Base Assembly - Westinghouse WHT401BR User Manual

SET UP & USE

BASE ASSEMBLY

1. Align the two halves of the base shaft to holes and slide together.
2. Turn unit so the bottom is facing upward.
3. Align the finished side of the base to the bottom of the unit matching the four
screw holes.
4. Insert the four wing nut screws into the four holes. Do not completely tighten.
5. Once all four screws are in place, you may completely tighten the screws.
6. Turn the unit over and stand it on the base. Be sure the unit is stable before going
further.
Bottom of Base
Page 7